Weed Eater World

This site is dedicated to videos and products for maintaining and using your weed eater.

I was given a Craftsman 358.791580 gas powered weed eater, straight shaft, fixed line.?

Written By: Weed Eater Guy - Sep• 06•15

There was no string in it, and I can not figure out how to make the pieces of string stay in the holes. There are two different sized holes, one set for large string and one for small string. If I just thread the string through the holes, it flies out.

To Find your next Weedeater or Weedeater parts visit

our Weedeater store

You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

One Comment

  1. Manila Mark says:

    Google your model and look for instruction manual or take it to Sears for some help there.

    You need to remove the cover on the bottom of the spool by turning it counter clockwise while pushing it down.Then tie the string around the spool, wine string on the spool, feed through the hole, replace the spool cover and let her rip. Good luck

Leave a Reply

Your email address will not be published. Required fields are marked *

Powered by Yahoo! Answers